PinPLUS cameras have an angle of viewfinder for 4x5 film on the top and one side of the camera. The top one has picture left side, right side, and center of pinhole vertical axis. The one side has picture top, bottom, and center of pinhole horizontal axis. The angle inside the outer excretion pins on top of camera is full picture view left and right. The angle inside the outer excretion pins on one side of camera is full picture view top and bottom for film in camera. For Polaroid 4 ½ x 3 ¼ that is 80% of a 4x5, will fall 10% inside of all outer film edge markings on the PinPLUS cameras.

PinPLUS cameras have carrying handles. The solid ¾ inch thick birch on the backside of the camera is the handle. This handle is placed near the center of gravity of the camera.

PinPlus cameras use pinhole assembles, thus pinholes can be removed for cleaning, and for replacement pinhole that make softer focus or sharper focus. Pinhole material used is 15/10,0000 thick stainless steel, unless noted. Different size pinhole assemblies are available at HueCandela.com.

PinPlus cameras have on the bottom side a ¼ -20 embedded steel bushing for tripod mounting. PinPLUS cameras are designed for horizontal mounting only. Use tripod head to rotate camera and film plane.

PinPLUS cameras have light baffles to control the unused light. A pinhole true view angle is over 170 degrees in all directions. 256 mm only used 27 degrees for 10 inch focal length camera. Only small percentage of the light through the pinhole is used to burn a film image.